Functional Safety Engineering
Provide hands-on Functional Safety engineering support for the development of safety-critical semiconductor IPs, ICs, and SoCs over the complete development safety lifecycle, from safety concept definition through implementation, analysis, and verification.
Activities & Deliverables:
SEooC Definition for Semiconductor / IP
- Definition of SEooC assumptions and safety boundaries
- Definition of IP/IC Safety Goal (Top Level Safety Requirement)
- ASIL , FHTI, Safe State
- Definition of assumptions of use and integration constraints
Safety Requirements Engineering
- Definition of Technical Safety Requirements (TSRs)
- Definition of Hardware Safety Requirements (HSRs)
- Definition of Software Safety Requirements (SSRs)
- Definition of Safety Mechanism Requirements
- Safety requirement decomposition and allocation
- Requirements traceability and consistency management
- Definition of safety-related interfaces and dependencies
Safety Architecture
- Definition of the Technical Safety Concept (TSC)
- Support for safety architecture development
- Safety partitioning and decomposition
- Definition and support of Safety Island architectures
- Freedom from Interference (FFI) analysis
- Definition of safety-related interfaces
- Definition and allocation of safety mechanisms
- Analysis of ASIL decomposition and independence
Safety Analysis
- FMEA / DFMEA
- FMEDA
- Fault Tree Analysis (FTA)
- Dependent Failure Analysis (DFA)
- Common Cause Analysis (CCA)
- Dependent Failure and interaction analysis
- FIT-rate and failure-rate calculations
- Calculation and evaluation of SPFM, LFM, and PMHF
- Diagnostic Coverage (DC) analysis
- Safety mechanism effectiveness analysis
- Analysis of single-point, residual, and latent faults
Safety Verification & Validation
- Safety mechanism verification planning
- Fault injection strategy and planning
- Safety verification planning
- Verification of safety requirements
- Verification of safety mechanisms
- Review and evaluation of verification results
- Generation and consolidation of objective safety evidence
- Support for safety case and assessment evidence
Contact
Tel.: +49 89 787 475-271
E-Mail: